Pertronix Dougs Headers D330 Bedienungsanleitung PDF herunterladen

Part No. 0110-003096 Page 1 of 4 8-15-2011 DSL

HEADER INSTALLATION INSTRUCTIONS

PART NUMBER: D330

Application:

1978-87 Buick Century, Regal, & Wagons

1978-87 Chevrolet Monte Carlo, Chevelle, Malibu, El Camino, & Wagons

1978-87 Pontiac Grand Prix, Le Mans, Grand Am (78-81), Grand Le Mans

With Chevrolet 265-400 Small Block Engines

NOTE: One tube on each header goes outside the frame, requiring that the

Inner fender be cut for clearance.

NOTE: Buick Models Only – Will NOT fit with 168 Tooth Flywheel

NOTE: Chevrolet Models Only – Will Fit with 168 Tooth Flywheel only when used with

Powermaster Mini Starter part #9500 or Equivalent.

PerTronix

thanks you for choosing

DOUG’S HEADERS

, the best fitting, highest quality header on the market. In order

to realize the full potential of our good fit, please read and understand these instructions completely prior to starting work.

Check to make sure you received the proper parts for your application. The header number will be stamped on the engine

flange. If you are unsure you have received the proper parts call before you start work.

Be sure to work safe! Whenever you work under the vehicle be sure that it is located on level, solid ground and is supported

by adequate safety stands! Remember: Hot asphalt will not support most jack stands!

Many factors affect the installation of headers, some of which are broken or aftermarket motor mounts, accidents that impact the

configuration of the frame, and/or the installation of different engines or aftermarket cylinder heads.

Attention Customers breaking in new engines: Due to the extreme heat generated during the break-in process, the

appearance of the ceramic coating may be altered in certain areas. The protection characteristics and thermal barrier properties

of the coating is never compromised. It is recommended that a cast iron manifold or old set of headers be used for this process.

Notice: The coating of these headers can be marred or scratched during installation. If the header needs to be returned and is

damaged, you will be charged for recoat.

DISASSEMBLY

1. Disconnect the negative battery cable from the battery.

2. If a car lift is not available, raise the vehicle 3 feet or higher and support with adequate

safety stands. Make sure the vehicle is on a flat solid surface and is stable.

Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 * FAX 909.599.6424 * www.dougsheaders.com

1 2 3 4

DISASSEMBLY 1
INSTALLATION 2

Inhaltsverzeichnis

Seite 1 - DISASSEMBLY

Part No. 0110-003096 Page 1 of 4 8-15-2011 DSL HEADER INSTALLATION

Seite 2 - INSTALLATION

Part No. 0110-003096 Page 2 of 4 8-15-2011 DSL 3. Remove the Spark P

Seite 3

Part No. 0110-003096 Page 3 of 4 8-15-2011 DSL IMPORTANT CHECK LIST

Seite 4

Part No. 0110-003096 Page 4 of 4 8-15-2011 DSL

Kommentare zu diesen Handbüchern

Keine Kommentare

Pertronix Dougs Headers D330 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Pertronix Dougs Headers D330 herunter. PerTronix Dougs Headers D330 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Pertronix Dougs Headers D330