440 E. Arrow Highway, San Dimas, CA. 91773
909-599-5955 www.pertronix.com
LIMITED WARRANTY
Pertronix, Inc. Warrants to the original Purchaser of its solid-state ignition system (product) that the
Ignitor, magnet assembly and wiring (components) shall be free from defects in material and workmanship for a
period of (30) months from the date of purchase.
If within the period of the foregoing warranty Pertronix finds, after inspection, that the product or any
component thereof is defective, Pertronix will, at its option, repair such products or component or replace them
with identical or similar parts PROVIDED that within such period Purchaser:
Promptly Notifies Pertonix, in writing, of such defects.1.
Delivers the defective products product or component to Pertronix (ATTN: Warranty) with proof of purchase 2.
date; and
Has installed and used the product in a normal and Proper manner, consistent with Pertronix printed 3.
instructions.
THE FORGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
WHETHER EXPRESSED OR IMPLIED, INCLUDING AND IMPLIED WARRANTY OR MERCHANTABILITY OR
FITNESS FOR A PURPOSE.
THE FURNISHING OF A REPAIR OR REPLACEMENT COMPONENTS SHALL CONSTITUTE THE SOLE
REMEDY OF PURCHASER AND THE SOLE LIABILITY OF PerTronix WHETHER ON WARRANTY, CONTRACT
OR FOR NEGLIGENCE, AND IN NO EVENT WILL PerTronix BE LIABLE FOR MONEY DAMAGES WHETHER
DIRECT OR CONSEQUENTIAL.
12-VOLT NEGATIVE GROUND INSTRUCTIONS
GENERAL INFORMATION
See our website (www.pertronix.com) for the latest product information. 1.
IMPORTANT: Read all instructions before starting installation.2.
WARNING!!! DO NOT USE WITH SOLID CORE IGNITION WIRES. 3.
The Ignitor II ignition can be used in conjunction with most ignition coils rated at 0.45 ohms or
4.
greater.
All external resistors must be removed to achieve optimum performance from the Ignitor II ignition 5.
system.
The Ignitor II is compatible as a trigger for most electronic boxes.6.
WARNING!!! DO NOT USE WITH SOLID CORE SPARK PLUG WIRES.
IGNITOR INSTALLATION
Remove distributor cap and rotor from distributor. Do not disconnect spark plug wires 1.
from cap. Examine cap and rotor for wear or damage. Replace as needed.
Disconnect the point wire from the negative (-) side of the coil. Remove the point wire, 2.
point, and condenser.
The distributor requires a minor modification 3.
NOTE: Distributor removal may be required.
File or drill the two rivets heads and remove the 4.
small bracket from the breaker plate. See figure 1.
Clean all dirt and excess oil from the breaker 5.
plate, point cam and distributor housing.
Install Ignitor plate over point pivot pin and line up hole 6.
on Ignitor plate to screw hole on breaker plate. Fasten
Ignitor plate to breaker plate using the screw provided.
Attach ground wire to breaker plate and distibutor 7.
housing, see figure 2.
Mount sleeve over distributor shaft, onto point cam. 8.
Rotate the sleeve until a slight locating position is felt
before applying pressure. Press down firmly insuring
sleeve is fully seated.
Insert wires through hole in the distributor housing 9.
and pull wire grommet into place. CAUTION: Care
must be taken to insure wires do not interfere with
moving parts.
For Part Number: 91362, 91569, 92561
Figure 2
Figure 1
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern