440 E. Arrow Highway, San Dimas, CA. 91773
909-599-5955 www.pertronix.com
LIMITED WARRANTY
Pertronix, Inc. Warrants to the original Purchaser of its solid-state ignition system (product) that the
Ignitor, magnet assembly and wiring (components) shall be free from defects in material and workmanship for a
period of (30) months from the date of purchase.
If within the period of the foregoing warranty Pertronix finds, after inspection, that the product or any
component thereof is defective, Pertronix will, at its option, repair such products or component or replace them
with identical or similar parts PROVIDED that within such period Purchaser:
1. Promptly Notifies Pertronix, in writing, of such defects.
2. Delivers the defective products product or component to Pertronix (ATTN: Warranty) with proof of purchase
date; and
3. Has installed and used the product in a normal and Proper manner, consistent with Pertronix printed
instructions.
THE FORGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
WHETHER EXPRESSED OR IMPLIED, INCLUDING AND IMPLIED WARRANTY OR MERCHANTABILITY OR
FITNESS FOR A PURPOSE.
THE FURNISHING OF A REPAIR OR REPLACEMENT COMPONENTS SHALL CONSTITUTE THE SOLE
REMEDY OF PURCHASER AND THE SOLE LIABILITY OF PerTronix WHETHER ON WARRANTY, CONTRACT
OR FOR NEGLIGENCE, AND IN NO EVENT WILL PerTronix BE LIABLE FOR MONEY DAMAGES WHETHER
DIRECT OR CONSEQUENTIAL.
12-VOLT NEGATIVE GROUND INSTRUCTIONS
GENERAL INFORMATION
1. See our website (www.pertronix.com) for the latest product information.
2. IMPORTANT: Read all instructions before starting installation.
3. WARNING!!! DO NOT USE WITH SOLID CORE IGNITION WIRES.
4.
The Ignitor II ignition can be used in conjunction with most ignition coils rated at 0.45 ohms or
greater.
5. All external resistors must be removed to achieve optimum performance from the Ignitor II ignition
system.
6. The Ignitor II is compatible as a trigger for most electronic boxes.
WARNING!!! DO NOT USE WITH SOLID CORE SPARK PLUG WIRES.
IGNITOR INSTALLATION
For Part Number: 9MR-163
1. PRIOR TO INSTALLATION TURN IGNITION SWITCH OFF OR DISCONNECT THE
BATTERY.
2. Remove distributor cap and rotor from distributor. Do not disconnect spark plug wires
from cap. Examine cap and rotor for wear or damage. Replace as needed.
3. Remove the points wire from the (-) terminal of the Ignition coil.
4. Remove screws that retain the original breaker plate and lift out the entire breaker plate
assembly from the distributor. Installing the Ignitor does not alter the internal configuration
of your distributor. Therefore, the points, condenser and hardware can be used as backup.
5. Clean all dirt and excess oil from the point cam.
6. Place the Ignitor module into the distributor housing and align the “X” mark on the plate to
the wire exit hole on the distributor housing. Fasten the plate into place using the original
screws.
7. Install magnet sleeve over the distributor shaft, onto point cam. Rotate the sleeve until a
slight locating position is felt before applying pressure. Press down firmly insuring sleeve
is fully seated.
8. Insert wires through the wire exit hole in distributor housing. Pull the rubber grommet into
place. Make sure wires do not interfere with any moving parts.
9. Re-install the rotor and distributor cap. Make sure all spark plug wires are securely
attached. WARNING!!! DO NOT USE WITH SOLID CORE SPARK PLUG WIRES.
10. See Wiring Instructions.
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern